Autel IM508 and XP400 Pro do FRM Repair

Autel IM508 and XP400 Pro do FRM Repair

Q: Does Autel IM508 support repair FRM boxes for BMW?

A: Confirmed: Autel IM508 and XP400 Pro can do FRM Repair. Here we go for a step-by-step procedure. (For IM508 with XP400 Pro, click here.)

Tap “Programmer”.


It says “Programmer is disconnected! Please connect the programmer first and click [OK].”, tap “Ok”.

Tap “Chip (EEPROM, MCU, ECU)”.

Tap “Chip read & write”.

Tap “Other”.

Tap “BMW”.

Tap “E-series ->RFM ->XEQ384 ->RW”.

Read the operation guide below.

1. Only “Read” and “Write” are supported at unencrypted status.
2. If the EEE or D-FLASH reads the data again after it has been written, and the data are inconsistent, please first execute “Write partition”, and then carry out normal read and write after the operation of “Write partition” is successful.
3. “Write partition” supports setting partition, but will lead to EEE or D-FLASH data loss.

Tap “D-FLASH” and “OK”.

Tap “Schematic diagram”.

There are diagrams and operation guides to follow.

Next is to follow the guide to do.